Emachines Flat Panel Monitor Manual de usuario descargar pdf (Pagina 12)

Using Your eMachines Flat-Panel Monitor

10 Press the bracket lever to the right and hold it, then lower the neck into place and release

the lever.

Adjusting monitor height tension

The stand is factory adjusted to maintain the height for your monitor. However, if it does not stay

in place when you let go, you need to change the stand’s height tension. You also need to adjust

the stand if the amounts of force required to raise and lower the monitor are not equal.

To adjust your monitor’s height tension:

1 Press the screwdriver access hole cap from below the base to remove it from the base.

Screwdriver access cap

8512327.book Page 8 Thursday, May 10, 2007 3:45 PM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Sin comentarios

Emachines Flat Panel Monitor Manual de usuario Pagina 12